Tone Detection Parameters - AudioCodes Mediant 800B User Manual

Parameter
MFC R2 Category
mfcr2-category
[R2Category]
Tone Index Table
Tone Index Table
configure voip > gw
analoggw tone-index
[ToneIndex]
61.10.9.2

Tone Detection Parameters

The signal tone detection parameters are described in the table below.
Parameter
DTMF-detector-enable
[DTMFDetectorEnable]
MFR1-detector-enable
[MFR1DetectorEnable]
[R1DetectionStandard]
user-defined-tones-
detector-enable
[UserDefinedToneDetectorEnable]
User's Manual
Defines the tone for MFC R2 calling party category (CPC). The
parameter provides information on the calling party such as
National or International call, Operator or Subscriber and
Subscriber priority.
The value range is 1 to 15 (defining one of the MFC R2 tones).
The default is 1.
Defines the Tone Index table, which allows you to define
distinctive ringing and call waiting tones per FXS endpoint (or
for a range of FXS endpoints).
The format of the ini file table parameter is as follows:
[ToneIndex]
FORMAT ToneIndex_Index = ToneIndex_FXSPort_First,
ToneIndex_FXSPort_Last, ToneIndex_SourcePrefix,
ToneIndex_DestinationPrefix, ToneIndex_PriorityIndex;
[\ToneIndex]
For example, the configuration below plays the tone Index #3 to
FXS ports 1 and 2 if the source number prefix of the received
call is 20.
ToneIndex 1 = 1, 2, 20*, , 3;
For a detailed description of the table, see Configuring FXS
Distinctive Ringing and Call Waiting Tones per
Source/Destination Number.
Note: The parameter is applicable only to FXS interfaces.
Table 61-64: Tone Detection Parameters
Enables the detection of DTMF signaling.

[0] = Disable

[1] = Enable (default)
Enables the detection of MF-R1 signaling.

[0] = Disable (default)

[1] = Enable
Determines the MF-R1 protocol used for detection.

[0] = ITU (default)

[1] = R1.5
Note: For the parameter to take effect, a device reset is required.
Enables the detection of User Defined Tones signaling,
applicable for Special Information Tone (SIT) detection.

[0] = Disable (default)

[1] = Enable
1108
Mediant 800B Gateway and E- SBC
Description
Description
Document #: LTRT-10296