AudioCodes Mediant 800B User Manual page 1143

User's Manual
Parameter
User Registration Grace Time
configure voip/sbc general-
setting/sbc-usr-reg-grace-
time
[SBCUserRegistrationGraceTime]
SBC DB Routing Search Mode
configure voip > sbc general-setting >
set sbc-db-route-mode
[SBCDBRoutingSearchMode]
Lync Capabilities Header
lync-cap-hdr-enable
[DeclareAudcClient]
Handle P-Asserted-Identity
p-assert-id
[SBCAssertIdentity]
Version 7.0
61. Configuration Parameters Reference
parameter in the Session-Expires header set to 'uac'.
Note: The time values of the Session-Expires (session
refresh interval) and Min-SE (minimum session refresh
interval) headers can be configured using the
SBCSessionExpires and SBCMinSE parameters,
respectively.
Defines additional time (in seconds) to add to the
registration expiry time of registered users in the device's
Users Registration database.
The valid value is 0 to 2,000,000. The default is 0.
Defines the method for searching a registered user in the
device's User Registration database when a SIP INVITE
message is received for routing to a user. If the registered
user is found (i.e., destination URI in INVITE), the device
routes the call to the user's corresponding contact address
specified in the database.

[0] All permutations = (Default) Device searches for the
user in the database using the entire Request-URI
(user@host). If not found, it searches for the user part
of the Request-URI. For example, it first searches for
"4709@joe.company.com" and if not found, it searches
for "4709".

[1] Dest URI dependant = Device searches for the user
in the database using the entire Request-URI
(user@host) only. For example, it searches for
"4709@joe.company.com".
Note: If the Request-URI contains the "tel:" URI or
"user=phone" parameter, the device searches only for the
user part.
Enables the device to be identified by an AudioCodes SBC
device as an AudioCodes analog device deployed in a
Microsoft Lync environment.

[0] Disable (default)

[1] Enable = Upon initial registration (REGISTER
message) of the analog device with the SBC device, the
SBC identifies the analog device as belonging to
AudioCodes and enabled for operating in the Lync
environment. Once registered, all subsequent calls (i.e.,
INVITE messages) received from the analog device or
destined to it are processed by the SBC.
Note: The parameter is applicable only to analog
interfaces.
Global parameter that defines the handling of the SIP P-
Asserted-Identity header. You can also configure this
functionality per specific calls, using IP Profiles
(IpProfile_SBCAssertIdentity). For a detailed description of
the parameter and for configuring this functionality in the IP
Profile table, see ''Configuring IP Profiles'' on page 396.
Note: If this functionality is configured for a specific IP
Profile, the settings of this global parameter is ignored for
1143
Description
Mediant 800B Gateway and E- SBC