Control Cable Terminals "Peripheral Board 4 - Siemens SINAMICS G180 Installation And Operating Instructions Manual

Operation
8.8 Examples / Applications
①
"Global" = functional for "Test" and "Normal"
②
If you use these inputs, remove the jumper.
③
As long as "P-INTERFACE: Reset-Source" is set to "Global" , all reset sources are always effective.
④
Max. current load of the control voltages:
● + 24 V DC, potential 2: 300 mA
● + 15 V DC, potential 2: 150 mA ± 10 mA
This voltage can also supply a speed encoder connected at terminal ‑X101.
Figure 8-36 Control cable terminals for "NAMUR" application
8.8.2.2

Control cable terminals "peripheral board 4"

NOTICE
Non-compliance with NAMUR guideline NE-37
The NAMUR guideline NE-37 is only completely implemented with the "peripheral board 4"
option.
126
Installation and operating instructions Sinamics G180
Operating Instructions, 05/2013, 4BS0751-001