Connecting A Pc To -X51 Via Rs 232 - Siemens SINAMICS G180 Installation And Operating Instructions Manual

Operation
8.4 Controlling the external connections of the inverter
The version of the installed IMS software must be "Z24" or higher. The USB connection feature
is not available in earlier versions.
In the menu "Options/drivers" select theUSB driver.
8.4.8

Connecting a PC to -X51 via RS 232

Figure 8-22
NOTICE
Damage to the inverter electronics or the PC.
The pins of socket -X51 are assigned signals other than those shown here. Do not use a
standard cable that is completely assigned, as otherwise the inverter electronics or the PC
could be damaged. Only use cables where only the required pins are assigned.
Further information about connecting PC and inverter, etc. can be found in the help in the
software "IMS".
● Connect the cable shield on both sides on the Sub-D9 case.
If you would like to use the software "IMS" to change the inverterparameters, the parameter
"P-INTERFACE/Para-Source" must be set to "Global" or "RS232" . "Global" is the default.
● Using the "IMS" software, configure which COM port the cable on the PC will be connected
● Select the configuration under "Options/Drivers/RS232-485-Driver" .
106
PC at ‑X51 via RS 232
to.
– The default setting is COM1.
Installation and operating instructions Sinamics G180
Operating Instructions, 05/2013, 4BS0751-001