Protecting Parameters Against Modification; Configuration Using The Inverter Display; More Documentation About Parameterization - Siemens SINAMICS G180 Installation And Operating Instructions Manual

Operation
8.7 Parameterization
8.7.2

Protecting parameters against modification

NOTICE
Incorrect parameter settings
The inverter and other connected components can be damaged or destroyed if the parameter
settings are incorrect.
Using the following measures, protect the parameter settings from unauthorized access.
You can configure all parameters of the inverter in the delivery condition using the internal
control panel or via an RS 232 connection to a PC with the "IMS" software.
If you would like that the inverter should only be configured from one location, you can set this
under "P-INTERFACE/Para-source".
If you would like to no longer allow any parameter changes, you must set the DIL switch S1.1
to "Off". The exact position of this DIL switch is described in the section "Sub-D connections
and DIL switches" (Page 100).
8.7.3

Configuration using the inverter display

1. You reach the configuration menu by pressing the button <P>. The display "P-DRIVE
2. Individual menu items can be selected using <up arrow> and <down arrow>. For example,
3. When "P-DRIVE DATA" is displayed, press <Return> in order to display the submenu of
4. If you press <Return> again, you see the display "A_Standard" for example on line two.
5. If you press <Return> again, you see the changed display "A=Namur 1". The cursor is then
6. Press <up arrow> or <down arrow> in order to change other parameters in the same menu.
You can then use the same principle of operation in any other menu.
8.7.4

More documentation about parameterization

You can find further documentation relating to parameterization on the Internet at
www.siemens.com (http://www.siemens.com)
118
DATA" is shown in the first line.
you reach "P-INTERFACE" using the <down arrow>.
"P-DRIVE DATA". The first parameter of "P-DRIVE DATA" "A=Standard" is shown in the
second line.
The indicated cursor means that you can input a new value for the parameter using <up
arrow> and <down arrow>.
no longer visible. The parameter is thus applied in the modified form.
Press <P> to go one level higher in the menu structure.
Installation and operating instructions Sinamics G180
Operating Instructions, 05/2013, 4BS0751-001