Operation According To "Namur 6 - Siemens SINAMICS G180 Installation And Operating Instructions Manual

Operation
8.3 NAMUR mode settings
8.3.7

Operation according to "NAMUR 6"

(D)
(S)
Figure 8-12
Operation different from "NAMUR 5"
The operation "Speed On" for "normal" mode is dynamic.
● Start the drive with a normally open contact at ‑X2:10.
● Issue the command "Speed Off" with an NC contact at ‑X2:11.
96
Dynamic: Pushbutton mode
Static: Switch mode
Assignment of the control cable terminals for "NAMUR 6" mode
Installation and operating instructions Sinamics G180
Operating Instructions, 05/2013, 4BS0751-001