Preparations For Use; Transporting Inverter - Siemens SINAMICS G180 Installation And Operating Instructions Manual

Preparations for use

4.1

Transporting inverter

Procedure
● Personnel operating cranes and fork-lift trucks must be appropriately qualified.
● Only use approved, undamaged and adequately dimensioned lifting equipment. Check the
Falling loads
If you are standing under a suspended load, then you are at risk of injury if the load falls off
the hoisting gear. This can result in death, serious injury or material damage.
Never stand in the area beneath a suspended load.
Accidents during transport and when lifting
This can result in death, serious injury or material damage.
Carefully observe the transport instructions in this document as well as the generally valid
accident prevention regulations – especially BGI 556.
Always wear personnel protective gear such as protective footwear and gloves and a helmet.
The inverters are packaged by the manufacturer so that they can be transported on trucks.
NOTICE
Damage to inverters during transportation
The inverters can become damaged if they are incorrectly transported.
Observe the environmental conditions for transport in the technical data.
● Transport compact devices with cardboard packaging horizontally and cabinet equipment
● Inverters are highly sensitive electronic devices. Pay attention to the stickers and warnings
● Only transport the equipment with modern, air suspension trucks on asphalt roads. If you
● Never lift the compact devices at the plastic cover, but always from below according to the
Installation and operating instructions Sinamics G180
Operating Instructions, 05/2013, 4BS0751-001
equipment before using it.
WARNING
WARNING
with plastic bubble wrap upright on wooden pallet.
on the packaging.
cannot comply with these conditions, package the devices in accordance with the special
requirements. Consult the factory for this, for example for marine packaging.
following diagrams.
4
33