Operation
8.3 NAMUR mode settings
8.3.3
Operation according to "NAMUR 2"
(D)
(S)
Figure 8-8
Operation different from "NAMUR 1"
The operation of the controller block for "Normal mode is dynamic.
● Start the drive with an NO (normally open) contact at –X2:10.
● You inhibit the inverter with a normally closed contact at ‑X2:11.
92
Dynamic: Pushbutton mode
Static: Switch mode
Assignment of the control cable terminals for "NAMUR 2" mode
Installation and operating instructions Sinamics G180
Operating Instructions, 05/2013, 4BS0751-001