Switching The Unit On And Off - Siemens SINAMICS G180 Installation And Operating Instructions Manual

Operation
8.1 Operation
8.1.2

Switching the unit on and off

Read the information in section "Safety instructions" (Page 13) before you switch on the unit.
Automatic startup
Depending on parameter settings and connection of external control devices, the inverter
can start up automatically when the line voltage is connected. The motor and coupled
machine can start moving unexpectedly. This can result in death, serious injury or material
damage.
Confirm whether or not your system is capable of automatic starting and, if appropriate, take
measures to ensure personal safety and operational readiness at the driven machine.
Startup
1. If your inverter is supplied with an external control voltage from external or auxiliary power
2. Switch on the line voltage.
3. Start up the inverter using the control command <On> or input the On command via an
80
Use the <down arrow> and <up arrow> buttons to navigate around the menu.
You specify the speed setpoint by pressing the buttons twice. This function is
only active if the setpoint has been set in the configuration.
Use these buttons as well to select individual actual values such as, e.g. "n-
Motor".
You reach the actual values menu by pressing this button.
Press the <ENTER> button to change to a submenu.
If you press the <S> button, you return to the status display with the actual values.
Acknowledge pending errors by pressing the <S+I> buttons simultaneously.
Press <P> to reach the parameters menu.
WARNING
sources, switch this supply on first.
external control device (if one is connected).
Installation and operating instructions Sinamics G180
Operating Instructions, 05/2013, 4BS0751-001