Plant Safety - Siemens SINAMICS G180 Installation And Operating Instructions Manual

Safety information

2.8 Plant safety

2.8 Plant safety
Read the following information about safeguarding the equipment.
Unsecured installation site
This inverter is intended for use in industrial power installations and machines.
Accidents can occur if the equipment is not used for the intended purpose, is incorrectly
operated, is inadequately maintained or can be accessed by unauthorized persons. Death,
serious injury or material damage will result.
Secure the installation site against unauthorized access when using the inverter outside
industrial areas using suitable equipment (e.g. safety fences) and corresponding signage.
Install the inverter in a suitable area to which only properly trained personnel have access.
Procedure
You are responsible for the safety of the system.
You must ensure that the following requirements are fulfilled:
● Basic planning and all the work involved in transporting, assembling, installing,
● The operating instructions and the complete product documentation are always available
● The technical data and specifications regarding the permissible installation, connection,
● The system-specific installation and safety regulations are observed and measures are
● It is prohibited for unqualified persons to work on these devices or in their vicinity.
The product documentation, especially the operating instructions, and the notices on the unit
itself therefore contain only the information required by qualified personnel to use the
installations or machines for their intended purpose.
Note
Siemens Service Centers
The services and support provided by the Siemens service centers are recommended for
planning, installation, commissioning, and servicing work.
Note
Engineering information
Systems in which the inverters are installed must be fitted with additional monitoring and
safety devices in order to comply with safety requirements (e.g. equipment and product safety
law, accident prevention regulations).
22
DANGER
commissioning, maintaining and repairing the equipment is only carried out by qualified
personnel or personnel supervised by responsible skilled technicians.
when carrying out any work.
environmental, and operating conditions are observed consistently.
taken to ensure personal safety.
Installation and operating instructions Sinamics G180
Operating Instructions, 05/2013, 4BS0751-001