Control Terminals - Siemens SED2 series Operating Instructions Manual

General information
Location of the control
terminals
Access to the control
terminals: Frame sizes A
to C
Access to the control
terminals: Frame sizes
D to F, IP20
38/126
Siemens Building Technologies
HVAC Products

4.4 Control terminals

Use only shielded cables for control cables.
Route control cables in separate cable trunks at least 20 cm away from motor and
power cables.
The control terminals are located on the I/O module. The I/O module is identical for all
models. It is located under the operator panel.
To access the control terminals, remove first the relevant terminal covers.
For frame size A, see section Access to connection terminals: Frame size A
on page 26.
For frame sizes B and C, see section Access to connection terminals: Frame sizes B
and C on page 27.
To access the control terminals, remove the operator panel, the I/O module, and the I/O
module terminal cover plate.
See section Access to connection terminals: Frame sizes D to F on page 28.
SED2 variable speed drives
Electrical installation
CM1U5192en
01.2002