Step 5 - Dress The Trunk And Drop Cable - Siemens SMIINV215R60XX Installation And Operation Manual

Step 5 – Dress the Trunk
a. Attach the Trunk
may use tie wraps. The cable clips are designed so that the drop cable from the may use tie wraps. The cable clips are designed so that the drop cable from the may use tie wraps. The cable clips are designed so that the drop cable from the
microinverter can also be dressed into the clip underneath the Trunk and Drop microinverter can also be dressed into the clip underneath
NOTE: There are two through
mounting, but are used to disconnect the connector. mounting, but are used to disconnect the connector. Keep these release holes
clear and accessible. clear and accessible.
b. Dress any excess cabling in loops so that it does Dress any excess cabling in loops so that it does not contact the roof. Do
the cabling to rest on the roof. There are several ways to support the cable. One the cabling to rest on the roof. There are several ways to support the cable. One the cabling to rest on the roof. There are several ways to support the cable. One
method is to place tie wraps or clips on either side of the Trunk and Drop method is to place tie wraps or clips on either side of the
Use one or two additional clips, tie wraps, or other support scheme to secure the Use one or two additional clips, tie wraps, or other
cable between connectors. cable between connectors.
Page 13
Trunk and Drop Cable
Trunk and Drop cabling to the rack using the recommended clips, or you and Drop cabling to the rack using the recommended clips, or you
: There are two through-holes in the trunk connector. These are
Copyright 2011 Siemens Industry, Inc. Copyri
holes in the trunk connector. These are not for
Keep these release holes
not contact the roof. Do not leave
support scheme to secure the
Trunk and Drop cable.
Trunk and Drop Connector.
141-00015, Rev 01