Using The Inside Controls; Burn Back Time; Gas Test; Wire Inch - Kemppi ArcFeed 200 Operating Manual

4.2

using the inside COntrOls

ArcFeed 200

4.2.1 Burn back time

Burn back time control knob (1) lets you adjust the length of the post-welding current. Using
Burn back feature makes it easy to stop welding without wire sticking or burning back to the
contact tip.

4.2.2 gas test

Gas test button (2) lets you test the shielding gas and measure the gas flow.

4.2.3 wire inch

Wire inch button (3) lets you drive the welding wire without turning on the welding current.
This feature can be used for example when feeding in the new wire.

4.2.4 post gas time

Post gas time (4) control knob lets you adjust the length of the post-welding gas flow. This
feature, combined with the burn back time, provides a smooth finish of the weld.
4.3

hAnging the deviCe

The Kemppi ArcFeed 200 wire feeder should never be hanged by its handle. Use a special
hanging frame for hanging it to a welding beam or other. See 'Accessories' in Chapter
'Ordering numbers' at the end of this manual.
The Kemppi ArcFeed 300, 300P and 300RC models can be hanged by their handle by using a
special hanging device, KFH 1000. See 'Accessories' in Chapter 'Ordering numbers' at the end
of this manual.
1
BURNBACK
WIRE INCH
2
GAS TEST
3
POST GAS
4
1 2 3 4
BURN POST
WIRE GAS
BACK GAS
INCH TEST
ArcFeed 300, 300p and 300rC
WIRE INCH
GAS TEST
POST GAS
EN
13