The Compressed-Air Motor; The Injection Unit; The Wire-Cutting Device; The Type Plate - Kemppi A7 Operating Manual

6.5 The compressed-air motor

This section describes the Robot Gun Cleaning Station's compressed-air motor.
Table 5: Compressed-air motor
Pneumatic motor's nominal speed with oiled air
Air consumption
Repository volume (anti-spatter fluid)
Air supply connection
Max. torque

6.6 The injection unit

This section describes the Robot Gun Cleaning Station's injection unit.
Table 6: Injection unit
Injection unit
Operating pressure
Max. actuation time
Consumption of anti-spatter fluid depends on the dosage setting.

6.7 The wire-cutting device

This section describes the Robot Gun Cleaning Station's wire-cutting device.
Table 7: Wire-cutting device
Cutting capacity at 6 bar
Solid wire
Cutting time
approx. 650 rpm at 6 bar
approx. 400 l/min
1 l
internal width 6 mm
8 Nm
1-liter bottle capacity
max. 6 bar
4 s
up to 1.6 mm
1.0 seconds
© Kemppi Oy 2016

6.8 The type plate

The Robot Gun Cleaning Station unit is labeled with a nameplate on the back as shown
in the figure.
Figure 3: The type plate
Before contacting the service staff, please remember to check the device type, device
number, ID number, year of construction, and switching type.
9
Robot Gun Cleaning Station 1616