Skoda FABIA 2000 Workshop Manual page 71

FABIA 2000 1.4/55; 1.4/74 Engine - Mechanical Components
–
Secure toothed belt gear -1- to the crankshaft with fix-
ing screw -2-.
–
Position crankshaft on TDC cylinder 1:
The chamfered tooth of the toothed belt must correspond
with the marking on the oil pump -arrow-.
–
Turn the crankshaft or if necessary toothed belt gear
from TDC three teeth anti-clockwise:
The third tooth to the right -arrow- of the chamfered tooth
-A- of the toothed belt gear must be flush with the TDC
marking on the oil pump housing.
Note
Turning will give the crankshaft the fitting position for the
oil pump. One of the four driver polygonal cams on the
crankshaft points upwards.
–
Remove main drive tensioning pulley.
–
Removing the oil pan ⇒ 17-1 page 3.
–
Removing the suction line ⇒ 17-1 page 1.
–
Remove crankshaft toothed belt sprocket.
–
Remove oil pump.
–
Remove gasket ring.
WARNING!
Wear protective gloves when working with sealant
and grease remover!
–
Clean sealing surface on cylinder block and on the oil
pump from sealant residues with chemical gasket re-
mover.
–
Degrease the sealing surfaces.
Installing
•
One of the four driver polygonal cams -arrow- on the
crankshaft points upwards.
Edition 05.05
S00.5306.06.20
Removing and installing parts of the lubrication system
17
17-1 5
page