Skoda FABIA 2000 Workshop Manual page 23

FABIA 2000 1.4/55; 1.4/74 Engine - Mechanical Components
–
Insert the two fixing pins through the locating holes of
the camshaft sprockets up to the stop in the fit holes
in the cylinder head cover.
Note
The two fixing pins are correctly inserted if the end parts
-D- are flush with line -A-.
–
Slide the support -B- up to the stop on the camshaft
timing gear -C-.
–
Counterhold V-ribbed belt pulley with counterholder
-T 30004- with inserted replaceable stu -T 30004/1-
and release the fixing screw for V-ribbed belt pulley
and toothed belt gear.
–
Remove belt pulley. Screw in the fixing screw with two
washers to secure the crankshaft.
–
For vehicles with air conditioning system remove the
ribbed V-belt tensioning pulley.
–
Remove bottom timing belt guard.
–
Mark the rotation direction of the two toothed belts.
Note
The camshaft sprockets must not be fixed when inspect-
ing the tensioning pulleys.
Inspecting main drive-tensioning pulley
–
Mark the pointer position of the tensioning pulley -ar-
row-. Load timing belt by firmly pressing down with
thumb. The pointer must move.
–
Relieve the toothed belt again.
–
Turn the crankshaft two turns in the running direction
of the engine.
–
Check pointer position. The pointer must return to its
initial position.
If the pointer does not return to its initial position:
–
Replace tensioning pulley.
Inspecting coupling drive-tensioning pulley
Edition 05.05
S00.5306.06.20
Disassembling and assembling engine
13
T30004
S13-0248
13-1 7
page