Skoda FABIA 2000 Workshop Manual page 48

15
22 - Rear timing belt guard
23 - Cylinder head cover
removing and installing ⇒ 15-1 page 4
24 - 10 Nm + torque a further
replace
Tighten crosswise from the middle outwards
25 - Main drive-toothed belt
before removing mark running direction
check for wear
do not kink
Toothed belt routing ⇒ Chapter 13-1
removing and installing, tensioning ⇒ Chapter 13-1
26 - Top toothed belt guard
removing and installing cylinder head
cover
Special tools, test and measuring equipment and
auxiliary items required
♦
Supporting device -MP 9-200-
♦
Pressure pad -T 30004- with replaceable stud
-T 30004/1-
♦ Camshaft lock -T 10016-
♦ Extractor -T 10094-
♦
Sealant -D 188 003 A1-
♦
Gasket remover Gasket Stripper (storage code GST,
storage article no. R 34402), manufacturer Retech
s.r.o.
♦
Cleaning agent and grease remover e.g.
-D 000 401 04-
Removing
–
First check whether a radio set with anti-theft coding
has been fitted. If this is the case obtain coding.
–
Disconnect the battery-earth strap with the ignition off.
–
Pull off hose -1- (for engines as of 04.02) and remove
engine protection -2- with air filter upwards -arrows-.
–
Remove the V-ribbed belt ⇒ Chapter 13-1.
15-1 4
page
FABIA 2000
turn (90 °)
1
/
4
Removing and installing cylinder head
1.4/55; 1.4/74 Engine - Mechanical Components
Edition 05.05
S00.5306.06.20