Skoda FABIA 2000 Workshop Manual page 57

FABIA 2000 1.4/55; 1.4/74 Engine - Mechanical Components
15-2 Repairing Valve Gear
1 - 20 Nm + torque a further
turn (90 °)
replace
to release and tighten use
tool -T 10016- ⇒ Fig. 1 in
15-2 page 2
2 - Camshaft sprocket
Pay attention to position the
timing belt when installing
⇒ Chapter 13-1
3 - Gasket ring
Lightly oil sealing lip
only replace with the cam-
shaft installed
replace ⇒ 15-2 page 6
4 - Coupling drive-toothed belt
before removing mark run-
ning direction
check for wear
do not kink
removing and installing, ten-
sioning ⇒ Chapter 13-1
5 - Cylinder head cover
removing and installing
⇒ Chapter 15-1
6 - 10 Nm + torque a further
turn (90 °)
replace
Tighten crosswise from the
middle outwards
7 - Cap
Holder for ignition transform-
er for engines with engine identification letters AUA, AUB
8 - 10 Nm
9 - Roller rocker arm
inspect roller bearings of roller for smooth operation
oil contact surfaces
for installing, clip onto hydraulic supporting element with locking clip
10 - Collets
11 - Cap
12 - 20 Nm
13 - Lifting eye
14 - Non-return valve, 6 Nm
Clean thread and secure with tool -D 154 102 A1-
do not tighten excessively, the valve can get stuck
15 - Hydraulic supporting element
do not interchange
before installing check axial play of the camshafts ⇒ Fig. 2 in 15-2 page 3
oil contact surfaces
16 - Valve spring retainer
17 - Valve spring
removing and installing with tool -MP 1-229- ⇒ 15-2 page 8
Edition 05.05
S00.5306.06.20
1
/
4
1 /
4
Repairing Valve Gear
15
15-2 1
page