10
–
Pull off hose -1- (for engines as of 04.02) and remove
the engine guard -2- with air filter upwards -arrows-.
–
Open cap of expansion reservoir to release pressure
in the cooling system.
–
Release the screws at the bottom of the engine cover
-arrows- and remove cover.
–
Unscrew front exhaust pipe from the exhaust manifold
⇒ Chapter 26-1 and tie to body member.
–
Remove pendulum support -arrows-.
–
Unscrew drive shaft to the right and left of the gearbox
and tie up ⇒ Body; Rep. Gr. 40.
–
Drain coolant ⇒ Chapter 19-1.
–
Pull off coolant hose at the top and bottom of the radi-
ator.
Note
When disconnecting hoses the residual coolant flows out!
Make sure a catch pan is positioned underneath.
–
Disconnect the plug connections on the connector be-
low the starter:
♦
Plug connection for lambda probe cable
♦
Plug connection to AC compressor cable
♦
Plug connection to generator cable
–
Disconnect plug connection of the reverse gear switch
from the gearbox.
–
Remove front bumper ⇒ Body work; Rep. Gr. 63.
–
Disconnect the following plug connections:
10-1
2
page
FABIA 2000
1.4/55; 1.4/74 Engine - Mechanical Components
Removing and Installing Engine
S10-0101
S10-0100
Edition 09.03
S00.5306.04.20