Skoda FABIA 2000 Workshop Manual page 40

13
–
Tighten the new fixing screws of the sealing flange
crosswise. Tightening torque: 12 Nm.
–
Install engine speed sender -arrow-. Tightening
torque: 5 Nm.
–
Installing oil pan ⇒ Chapter 17-1.
–
Fit the intermediate plate.
–
Install the flywheel or driver disc with new screws
⇒ 13-2 page 3.
E - Pressing down the rotor
–
Screw assembly device -T 10017- or -T 10134- with
Allan screws up to the stop onto the crankshaft flange.
–
Screw in three knurled screws -C- into the flange.
–
Screw in hexagon nut -D- by hand onto the threaded
spindle until it rests against the assembly cup -A-.
–
Tighten the hexagon nut of the assembly device using
a torque wrench with adapter. Tightening torque: 40
Nm.
–
Again inspect the fitting position of the rotor on the
crankshaft ⇒ 13-2 page 11.
If the dimension -a- is again too small:
–
Tighten the hexagon nut of the assembly device to 45
Nm.
–
Again inspect the fitting position of the rotor on the
crankshaft ⇒ 13-2 page 11.
13-2 12
page
FABIA 2000
Removing and installing cylinder block
1.4/55; 1.4/74 Engine - Mechanical Components
Edition 05.05
S00.5306.06.20