Skoda FABIA 2000 Workshop Manual page 51

FABIA 2000 1.4/55; 1.4/74 Engine - Mechanical Components
Further installation occurs in a similar way in reverse or-
der to removal.
Removing and installing cylinder head
Special tools, test and measuring equipment and
auxiliary items required
♦ Supporting device -MP 9-200-
♦ Pressure pad -T 30004- with replaceable stud
-T 30004/1-
♦ Bracket -T 10014-
♦ Camshaft lock -T 10016-
♦ Catch pan, e.g. -V.A.G 1306-
♦ Sealant -D 188 003 A1-
♦
Gasket remover Gasket Stripper (storage code GST,
storage article no. R 34402), manufacturer Retech
s.r.o.
Requirements
•
The engine must not exceed the temperature of 35°C,
because the cylinder head could twist when loosening
the screws.
•
The pistons must not be in TDC.
Removing
–
Remove cylinder head cover ⇒ 15-1 page 4.
–
Open and close the cap of the expansion reservoir to
reduce the pressure in the cooling system.
–
Drain coolant ⇒ Chapter 19-1.
–
Release spring strap clamps and disconnect the cool-
ant hoses of the coolant regulator housing.
Note
When separating the hoses the residual coolant flows
out! Make sure a catch pan is positioned underneath.
–
Unscrew the front exhaust pipe from the exhaust man-
ifold and hook up ⇒ Chapter 26-1.
–
Remove the top fixing screw of the guide pipe for the
oil dipstick.
–
Disconnect the connectors of the injection valves -ar-
rows-.
–
Remove the fuel rail with injection valves and lay
aside.
–
Remove exhaust manifold from cylinder head.
–
Release or disconnect the following components:
♦ Hose from the crankcase ventilation
♦ Hose from the activated charcoal filter system to the
intake manifold
Edition 05.05
S00.5306.06.20
Removing and installing cylinder head
15
15-1 7
page