Skoda FABIA 2000 Workshop Manual page 33

FABIA 2000 1.4/55; 1.4/74 Engine - Mechanical Components
–
Screw 3 screws M6x35 into the threaded bores of the
sealing flange -arrows-.
–
Press out sealing flange together with rotor from the
crankshaft by alternately screwing the screws into the
sealing flange.
Note
♦ For 1.4/55 kW engine with engine identification char-
acters BKY in combination with manual gearbox, the
assembly device -T10134- is used for installing the
sealing flange. In all other cases use the assembly de-
vice -T 10017-.
♦ New sealing flange is supplied from the spare parts
catalogue with two gasket ring versions. Old versions
of engines use elastomer gasket ring with spring and
new engines use PTFE gasket ring.
♦ The sealing flange with PTFE gasket ring is provided
with sealing lip supporting ring. This supporting ring is
intended as an assembly sleeve and must not be re-
moved before installing.
♦ Do not separate or turn the sealing flange and rotor af-
ter removing them from the spare part package.
♦ The rotor is given its fitting location by positioning the
assembly device -T 10017- or -T10134- to the posi-
tioning pin.
♦ The rotor has an elastomer layer on its sealing surface
with the crankshaft. This layer must not be brought
into contact with dirt or grease.
♦ The sealing flange and gasket ring form one unit and
must be replaced together with the rotor.
♦ The assembly device -T 10017- or -T10134- is given
its fitting location to the crankshaft by means of a
guide bolt, which is guided into the threaded bore of
the crankshaft.
A - Mounting the sealing flange with rotor on the
assembly device -T 10017- or -T10134-
A - Hexagon nut
B - Clamping surface
C - Assembly cup
D - Allan screw
E - Guide bolts (for assembly device -T 10134- with black
handle - for fuel engine)
F - Positioning pin
E - Guide bolts (for assembly device - T 10134- with red
handle - for diesel engine)
Note
Unless otherwise indicated, the method for the assembly
device -T 10017- and -T10134- is identical.
Edition 05.05
S00.5306.06.20
Removing and installing cylinder block
13
13-2 5
page