Skoda FABIA 2000 Workshop Manual page 70

17
Installing
Note
♦ Pay attention to the 'use by date' on sealant.
♦ The oil pan must be installed within 5 minutes after ap-
plying the silicone sealant.
♦ The oil pan can be better and more securely installed
if M6 threaded pins are inserted as guides in two loca-
tions on the cylinder block flange.
–
Cut off nozzle tube at the front marking (∅ nozzle ap-
prox. 3 mm).
–
Apply silicone sealant to the clean sealing surface of
the oil pan, as shown in the illustration. Sealant bead
must:
♦
be 2...3 mm thick
♦ run past the area around the bolt holes on the inside
-arrows-
Note
The sealant bead must not be thicker otherwise excess
sealant may get into the oil pan and clogg the strainer in
the oil suction pipe.
–
Fit oil pan immediately and lightly tighten all oil pan
screws.
–
Tighten the oil pan screws to tightening torque:
♦ Metal oil pan: 15 Nm
♦ Aluminium oil pan: 13 Nm - replace screws
–
Tighten up the bolts on the oil pan/gearbox to a torque
of 45 Nm.
Note
After installing the oil pan, allow the sealant to dry for
about 30 minutes. Only then may engine oil be filled in.
Removing and installing oil pump
Special tools, test and measuring equipment and
auxiliary items required
♦
Bushing -T 10022-
♦
Gasket remover Gasket Stripper (storage code GST,
storage article no. R 34402), manufacturer Retech
s.r.o.
♦
Cleaning agent and grease remover e.g.
-D 000 401 04-
♦ Inserting device -MP 1-207-
Removing
–
Removing the main drive - toothed belt ⇒ Chapter 13-
1.
17-1 4
page
FABIA 2000
Removing and installing parts of the lubrication system
1.4/55; 1.4/74 Engine - Mechanical Components
Edition 05.05
S00.5306.06.20