Skoda FABIA 2000 Workshop Manual page 32

13
–
Check dimension -a- in three points and determine
mean value. Specified value: 19.7...21.3 mm.
Note
The measurement is made through the hole of the drive
plate to the milled surface of the cylinder block.
If the specified value is not reached:
–
Remove driver disc and use compensating washer
-2-. Tighten screws -3- again to 30 Nm and again
check the dimension -a-.
If the specified value is reached:
–
Tighten screws -3- to 60 Nm and torque a further
turn (90°) (the tightening may occur in several stages).
Replacing the sealing flange for crank-
shaft - flywheel side
Special tools, test and measuring equipment and
auxiliary items required
♦ Assembly fixture -T 10017- or -T10134-
♦ 3 Hexagon screws M6×35 mm
♦ Feeler gauge
♦ Steel straightedge
♦
Torque wrench
Removing sealing flange with rotor
Note
These work sequences with the engine removed are
shown for purposes of clear presentation. The work se-
quences are identical with the engine installed and gear-
box removed.
–
Remove flywheel or driver disc ⇒ 13-2 page 3.
–
Remove intermediate plate.
–
Position engine to TDC of cylinder 1 ⇒ Chapter 13-1.
–
Removing oil pan ⇒ Chapter 17-1.
–
Remove engine speed sender -arrow-.
–
Release the fixing screws of the sealing flange.
13-2 4
page
FABIA 2000
1
/
4
Removing and installing cylinder block
1.4/55; 1.4/74 Engine - Mechanical Components
2
a
S13-0302
1
3
S13-0301
Edition 05.05
S00.5306.06.20