FABIA 2000
1.4/55; 1.4/74 Engine - Mechanical Components
–
Release screws -arrows- from engine mounting -A-
and from the gearbox mount -B-.
–
Lower engine/gearbox unit and push towards the
front.
Note
The engine/gearbox unit must be guided carefully so as
not to damage the body.
Attaching engine to assembly stand
Secure the engine with engine mount -MP 1-202- on the
tensioning block -MP 9-101 - before performing assem-
bly work.
–
Unscrew gearbox from engine.
Vehicles with automatic gearbox
–
After disconnecting the engine from the gearbox se-
cure torque converter against „dropping out".
Continued for all vehicles
–
Screw engine on engine mount -MP 1-202- -arrows-
secured to tensioning block -MP 9-101-.
Note
Because of the different bore distances in the engine
mount and bores in the engine flange the engine can only
be supported in three points.
Installing
–
Check whether dowel sleeves for centering have been
inserted in the cylinder block, if necessary insert.
–
Insert intermediate plate on sealing flange and push
onto the dowel sleeves -arrows-.
–
Pay attention to correct fit of the intermediate plate.
–
Check the centering of the clutch driver disc.
–
Inspect clutch release bearing for wear, replace if nec-
essary.
–
Slightly grease the clutch release bearing, guide
bushing for clutch release bearing and serration of the
gearbox drive shaft with grease -G 000 100-.
–
Assemble engine with gearbox ⇒ Gearbox 02T;
Rep. Gr. 34 or ⇒ Automatic Gearbox 001;
Rep. Gr. 37.
Edition 09.03
S00.5306.04.20
A
B
Removing and Installing Engine
10
S10-0109
MP1-202
MP9-101
S10-0129
N10-0160
10-1
5
page