Skoda FABIA 2000 Workshop Manual page 18

13
Removing and installing V-ribbed belt
Special tools, test and measuring equipment and
auxiliary items required
♦ Clamping lever -MP 1-203-
Vehicles with air conditioning
Routing of the V-ribbed belt
Belt drive with AC compressor:
1 - AC generator - belt pulley
2 - AC compressor - belt pulley
3 - Crankshaft toothed belt sprocket
4 - Tensioning pulley
Removing
–
Remove the noise insulation.
–
Mark the rotation direction of the V-ribbed belt.
–
Swivel out tensioning pulley with a wrench in -direc-
tion of arrow-.
–
Remove the V-ribbed belt. If necessary the tensioning
pulley can be secured by inserting the socket wrench
into the lock opening.
Installing
–
First lay the V-ribbed belt on the crankshaft timing belt
sprockett, then on the AC compressor belt pulley.
–
Release tensioning pulley with the wrench and pull the
belt over the AC generator - belt pulley.
–
Check whether the ribbed V-belt fits correctly in the
ribbing of all tensioning pulleys.
–
Check belt with the engine running in idle.
–
Install the noise insulation.
Note
♦
Pay attention to the running direction when installing
the V-ribbed belt.
♦ Replace damaged V-ribbed belt.
♦ If the belt is considerably worn it must be replaced.
♦ Do not fold or buckle the belt when handling it!
Vehicles without air conditioning
Removing
–
Remove the noise insulation.
–
Release fixing screws for AC generator.
13-1 2
page
FABIA 2000
Disassembling and assembling engine
1.4/55; 1.4/74 Engine - Mechanical Components
3 4
1
2
S13-0206
S13-0205
Edition 05.05
S00.5306.06.20