19
Note
♦
The integrated gasket of the coolant pump must not
be removed from the pump.
♦
If leak and damage present, replace the coolant pump
with gasket completely.
♦
Cover the toothed belt with a cloth before removing
the coolant pump in oder to protect it from the coolant.
Removing
–
Drain coolant ⇒ 19-1 page 5.
–
Removing the main drive - toothed belt ⇒ Chapter 13-
1.
–
Remove guide pulley -6-; to this end release the fixing
screw -5- of the guide pulley.
–
Unscrew the fixing screw -1- of the toothed belt guard
at rear.
–
Unscrew the fixing screws -4- of the coolant pump and
remove the toothed belt guard at rear -2- and the cool-
ant pump -3-.
Installing
Installation is performed in the reverse order. Pay atten-
tion to the following points:
–
Position the coolant pump -3- in the cylinder block and
install fixing screws -4- together with rear toothed belt
guard. Tightening torque: 20 Nm.
–
Install guide pulley -6- and tighten the fixing screw -5-.
Tightening torque: 50 Nm.
–
Install fixing screw -1- of the toothed belt guard at rear
-2-. Tightening torque: 10 Nm.
–
Installing the timing belt, tightening ⇒ Chapter 13-1.
–
Install the V-ribbed belt ⇒ Chapter 13-1.
–
Filling system with coolant ⇒ 19-1 page 5.
19-1
8
page
FABIA 2000
1.4/55; 1.4/74 Engine - Mechanical Components
Parts of the Cooling System
Edition 05.05
S00.5306.06.20