Skoda FABIA 2000 Workshop Manual page 17

FABIA 2000 1.4/55; 1.4/74 Engine - Mechanical Components
13 – Crankgear
13-1 Disassembling and assembling engine
Summary of components of ribbed V-belt on vehicles fitted with AC
1 - Tensioning pulley for ribbed
V-belt
Swing out the tensioning pul-
ley with ring spanner
The tensioning pulley can be
secured by inserting the
socket wrench into the fit
hole
2 - Compact holder
for AC generator, AC com-
pressor and tensioning pul-
ley for ribbed V-belt
3 - 50 Nm
Tightening sequence: first
top right bolt, then bottom
right bolt, and last the bolts at
the left (looking in direction of
travel)
4 - 23 Nm
5 - AC generator
removing and installing
⇒ Electrical System;
Rep. Gr. 27
to facilitate the positioning of
the AC generator drive the
threaded bushings of the
screws on the generator
slightly backwards
6 - 20 Nm + torque a further
turn (90 °)
7 - Bushing
2 pieces
8 - 25 Nm
9 - AC compressor
removing and installing ⇒ Heating, Air Conditioning; Rep. Gr. 87
10 - V-ribbed belt
before removing mark running direction
check for wear
removing and installing ⇒ 13-1 page 2
Routing of toothed belt ⇒ 13-1 page 2
11 - V-ribbed belt pulley
12 - 90 Nm + torque a further
replace
tightening may occur in successive stages
the torquing angle can be measured with a commercially available angle measuring plate, e.g. -Hazet 6690-
Edition 05.05
S00.5306.06.20
1 /
4
turn (90 °)
1 /
4
Disassembling and assembling engine
13
13-1 1
page