Skoda FABIA 2000 Workshop Manual page 47

FABIA 2000 1.4/55; 1.4/74 Engine - Mechanical Components
Engines with engine identification letters BKY
1 - Coupling drive-toothed belt
before removing mark run-
ning direction
check for wear
do not kink
removing and installing, ten-
sioning ⇒ Chapter 13-1
2 - 10 Nm
3 - Cable guide
Tighten at cylinder head cov-
er to 8 Nm
4 - Spacer, 6 Nm
for air filter housing
5 - Coolant pipe
6 - From air filter
7 - Non-return valve
8 - Hall sender -G40-
9 - O-ring
replace
10 - Bracket
11 - Roller rocker arm
inspect roller bearings of roll-
er for smooth operation
oil contact surfaces
for installing, clip onto hy-
draulic supporting element
with locking clip
12 - Lifting eye
13 - 20 Nm
14 - Dowel pins
15 - Hydraulic supporting element
do not interchange
oil contact surfaces
before installing, inspect axial play of the camshafts ⇒ Chapter 15-2
16 - Cylinder head bolt
replace
observe the mounting instructions and sequence for loosening and tightening ⇒ 15-1 page 7
17 - Oil pressure switch 0.03 ... 0.07 MPa (0.3 ... 0.7 bar) -F1-, 25 Nm
inspect ⇒ Chapter 17-1
Cut open gasket ring if leaking and replace
18 - Cylinder head gasket
replace
metal gasket
19 - Cylinder head
removing and installing ⇒ 15-1 page 7
check for distortion ⇒ Fig. 1 in 15-1 page 2
Sealing surfaces on the cylinder head cover must be free of oil and grease.
after replacing fill entire system with fresh coolant
20 - Coupling drive-tensioning pulley
inspect ⇒ Chapter 13-1
Tension the toothed belt ⇒ Chapter 13-1
21 - 20 Nm
Edition 05.05
S00.5306.06.20
Removing and installing cylinder head
15
15-1 3
page