FABIA 2000
1.4/55; 1.4/74 Engine - Mechanical Components
Procedure
–
Position crankshaft on TDC cylinder 1. The chamfered
tooth must correspond with the marking on the sealing
flange -arrow-.
–
Fit the coupling drive - toothed belt. If the toothed belt
has been used pay attention to the rotation direction.
Install the coupling drive-tensioning pulley as follows:
–
Turn the coupling drive-tensioning pulley with Allen
screw -1- clockwise in the direction of the marking
window -arrow- (tensioning pulley in released posi-
tion).
–
Push the bottom part of the coupling drive-toothed belt
upwards using the tensioning pulley and screw in the
fixing screw of the tensioning pulley.
–
Tighten fixing screw manually. The peg of the base
plate -2- must engage in the bore on the cylinder
head.
–
Subsequently tension the toothed belt by turning the
tensioning pulley with an Allan key pos. -1- in -direc-
tion of arrow A- until the pointer -2- is positioned over
the peg in the base plate in the marking window -ar-
row-.
–
Tighten fixing screw of the tensioning pulley to 20 Nm.
–
Remove camshaft lock -T 10016-.
–
Turn the crankshaft or toothed belt gear from TDC half
a tooth anti-clockwise (approx 1.5 mm).
–
Fit the main drive - toothed belt.
–
Fix the two camshaft sprockets with camshaft lock
-T 10016-.
Fitting main drive-tensioning pulley:
Edition 05.05
S00.5306.06.20
Disassembling and assembling engine
13
S13-0509
1
A
2
S13-0322
13-1
9
page