Skoda FABIA 2000 Workshop Manual page 68

17
pay attention to installation instructions on oil filter
15 - Oil pump
with pressure relief valve, open for an overpressure of 0.45 MPa (4.5 bar)
must be replaced completely
when fitting pay attention to the driver on the crankshaft ⇒ item 30
must be positioned on dowel sleeves
removing and installing ⇒ 17-1 page 4
16 - 12 Nm
replace
17 - Crankshaft toothed belt sprocket
pay attention to locating element when installing
18 - Gasket ring
replacing ⇒ Chapter 13-1
19 - Suction line
out of plastic
as of 06.04 for vehicles with a manual gearbox
Clean strainer if dirty
20 - 20 Nm
21 - Gasket
replace
22 - Suction line
out of metal
as of 06.04 only for vehicles with an automatic gearbox
Clean strainer if dirty
23 - Tensioning pulley
for main drive-toothed belt
Tension the toothed belt ⇒ Chapter 13-1
24 - Oil level/temperature sender -G266-
only for vehicles with extended service intervals (WIV)
check ⇒ Current Flow Diagrams, Electrical Fault Finding and Fitting Locations
25 - Gasket
replace
26 - Oil pan
removing and installing ⇒ 17-1 page 3
clean sealing surface before installing
install with silicone sealant -D 176 404 A2-
27 - Oil drain plug, 30 Nm
replace
28 - Fixing screw
Metal oil pan: 15 Nm
Aluminium oil pan: 13 Nm - replace screws
slacken and tighten only the bolts at the flywheel side with wrench bit -T10058- or -3249-.
29 - 45 Nm
30 - Driver
coat with oil before installing the oil pump
31 - Gasket ring
replace
32 - Oil separator
with heated vacuum regulating valve (PCV valve)
Resistance of heating element at 25°C: 2,5 - 5,9 Ω
Design for engines with the engine codes BBY, BKY and BBZ
33 - Connector
for heating resistor of crankcase ventilation -N79-
17-1 2
page
FABIA 2000
Removing and installing parts of the lubrication system
1.4/55; 1.4/74 Engine - Mechanical Components
Edition 05.05
S00.5306.06.20