FABIA 2000
1.4/55; 1.4/74 Engine - Mechanical Components
–
Position clamping lever -MP 1-203-, secure by insert-
ing a pin and and push AC generator towards the
crankshaft.
Remove the released ribbed V-belt from the AC genera-
tor - belt pulley.
Installing
–
Lay the V-ribbed belt on the toothed belt sprocket
crankshaft.
–
Push AC generator down and fit on belt.
Once the AC generator is released the belt is tensioned
to nominal voltage.
–
After fitting the ribbed V-belt, crank the engine several
times with the starter (about 10 turns) once the AC
generator screws are released.
–
First tighten the bottom and then the top screw for AC
generator to 20 Nm.
–
Install the noise insulation.
Summary of components of timing belt
1 - Top toothed belt guard
2 - 20 Nm
3 - Tensioning pulley
check ⇒ 13-1 page 4
Tensioning toothed belt
⇒ 13-1 page 4
4 - Timing belt
before removing mark run-
ning direction
check for wear
do not kink
Routing of toothed belt
⇒ Fig. 1 in 13-1 page 4
removing and installing, ten-
sioning ⇒ 13-1 page 4
5 - Rear timing belt guard
6 - 10 Nm
7 - Lifting eye
8 - 25 Nm
9 - Guide pulley
10 - Bracket
11 - 50 Nm
12 - Coolant pump
with integrated gasket -
warning - it must not be re-
moved from the pump, re-
place completely if leaking or
damaged
removing and installing
⇒ Chapter 19-1
Edition 05.05
S00.5306.06.20
Disassembling and assembling engine
13
13-1
3
page