Table of Contents
Advertisement
Router Interface Commands
To remove the type cpm-np option, re-issue the bfd command without specifying the type
parameter.
Default
no bfd
Parameters
transmit-interval — Sets the transmit interval, in milliseconds, for the BFD session.
receive receive-interval — Sets the receive interval, in milliseconds, for the BFD session.
multiplier multiplier — Set the multiplier for the BFD session.
echo-receive echo-interval — Sets the minimum echo receive interval, in milliseconds, for the
type cpm-np — Selects the CPM network processor as the local termination point for the BFD
cflowd
Syntax
cflowd {acl | interface} [direction]
no cflowd
Context
config>router>interface
Description
This command enables cflowd to collect traffic flow samples through a router for analysis.
cflowd is used for network planning and traffic engineering, capacity planning, security, application
and user profiling, performance monitoring, usage-based billing, and SLA measurement. When
cflowd is enabled at the interface level, all packets forwarded by the interface are subjected to
analysis according to the cflowd configuration.
If cflowd is enabled without either egress-only or both specified or with the ingress-only keyword
specified, then only ingress sampling will be enabled on the associated IP interface.
Page 154
2.
The service is shut down (shutdown)
3.
The interval is specified 10 — 100000.
4.
The service is re-enabled (no shutdown)
Values
10 — 100000
10 — 100000 (see Important Notes above)
Default
100
Values
10 — 100000
10 — 100000 (see Important Notes above)
Default
100
Values
3— 20
Default
3
session.
Values
100 — 100000
Default
0
session. See Important Notes, above.
7750 SR OS Router Configuration Guide
Advertisement
Table of Contents
