Table of Contents
Advertisement
Router Global Commands
Table 5: Default Route Preferences
enable — Static routes can be administratively enabled or disabled. Use the enable parameter to re-
disable — Static routes can be administratively enabled or disabled. Use the disable parameter to
bfd-enable — Associates the state of the static route to a BFD session between the local system and
mcast-family — Enables submission of the IPv4 or IPv6 static route into IPv4 or IPv6 multicast
rsvp-te — This parameter allows the static route to be resolved via an RSVP-TE based LSP. The
cpe-check target-ip-address — This parameter specifies the IP address of the target CPE device.
Page 126
Label
IS-IS level 2 internal
OSPF external
IS-IS level 1 external
IS-IS level 2 external
BGP
Default
5
Values
1 — 255
enable a disabled static route. In order to enable a static route, it must be uniquely identified by
the IP address, mask, and any other parameter that is required to identify the exact static route.
The administrative state is maintained in the configuration file.
Default
enable
disable a static route while maintaining the static route in the configuration. In order to enable a
static route, it must be uniquely identified by the IP address, mask, and any other parameter that
is required to identify the exact static route.
The administrative state is maintained in the configuration file.
Default
enable
the configured nexthop. This keyword cannot be configured if the indirect or blackhole
keywords are specified. The remote end of the BFD session must also be configured to originate
or accept the BFD session controlling the static-route state.
RTM.
Values
mcast-ipv4, mcast-ipv6
static route nexthop will be resolved via the best RSVP-TE based LSP to the associated indirect
next hop. By default, if an RSVP-TE LSP is not available, the IGP route table will be used to
resolve the associated nexthop. If the keyword "disallow-igp" is configured, the associated static
route will not be resolved through the IPv4 route table if an RSVP-TE based LSP is not
available.
ICMP pings will be sent to this target IP address. This parameter must be configured to enable
the CPE connectivity feature for the associated static route. The target-ip-address cannot be in
Preference
Configurable
18
Yes
150
Yes
160
Yes
165
Yes
170
Yes
7750 SR OS Router Configuration Guide
Advertisement
Table of Contents
