Table of Contents
Advertisement
Router Interface Commands
strip-label
Syntax
[no] strip-label
Context
config>router>interface
Description
This command forces packets to be stripped of all (max 5) MPLS labels before the packets are
handed over for possible filter (PBR) processing.
If the packets do not have an IP header immediately following the MPLS label stack after the strip,
they are discarded. Only MPLS encapsulated IP, IGP shortcuts and VPRN over MPLS packets will
be processed.
This command is only supported on:
The no form of the command removes the strip-label command.
In order to associate an interface that is configured with the strip-label parameter with a port, the port
must be configured as single-fiber for the command to be valid.
Default
no strip-label
teid-load-balancing
Syntax
[no] teid-load-balancing
Context
config>router>interface
Description
This command enables inclusion of TEID in hashing for GTP-U/C encapsulates traffic for GTPv1/
GTPv2. The no form of this command ignores TEID in hashing.
Default
disabled
tos-marking-state
Syntax
tos-marking-state {trusted | untrusted}
no tos-marking-state
Context
config>router>interface
Description
This command is used on a network IP interface to alter the default trusted state to a non-trusted state.
When unset or reverted to the trusted default, the ToS field will not be remarked by egress network IP
interfaces unless the egress network IP interface has the remark-trusted state set, in which case the
Page 168
• Optical ports
• IOM3-XP cards
• Null/Dot1q encaps
• Network ports
• IPv4
7750 SR OS Router Configuration Guide
Advertisement
Table of Contents
