Table of Contents
Advertisement
etc) fragments of a fragmented packet since only the first fragment contains the Layer 4 information.
The no form of the command removes the destination port match criterion.
Default
none
Parameters
lt | gt | eq — Specifies the operator to use relative to dst-port-number for specifying the port number
eq — Specifies the operator to use relative to dst-port-number for specifying the port number match
dst-port-number — The destination port number to be used as a match criteria expressed as a decimal
port-list-name — A string of up to 32 characters of printable ASCII characters. If special characters
range start end — Specifies an inclusive range of port numbers to be used as a match criteria. The
flow-label
Syntax
flow-label flow-label [mask]
no flow-label
Context
config>filter>ipv6-filter>entry>match
Description
This command configures the flow-label and optional mask match condition.
The no form of the command reverts to the default.
Default
no flow-label
Parameters
flow-label — Specifies the flow label to be used as a match criterion.
mask — Specifies the flow label mask value for this policy IP Filter entry.
7750 SR OS Router Configuration Guide
match criteria.
lt specifies all port numbers less than dst-port-number match.
gt specifies all port numbers greater than dst-port-number match.
eq specifies that dst-port-number must be an exact match.
criteria. The eq keyword specifies that dst-port-number must be an exact match.
integer.
Values
0 — 65535
are used, the string must be enclosed within double quotes.
destination port numbers start-port and end-port are expressed as decimal integers.
Values
0 — 65535
Values
0 — 1048575
Values
0 — 1048575 decimal hex or binary
Filter Policies
Page 503
Advertisement
Table of Contents
