Alcatel-Lucent 7750 SR-OS Configuration Manual page 664

Common CLI Command Descriptions
bgprp-id — Specifies the bundle protection group ID to be associated with this IP interface. The bpgrp
keyword must be entered at the beginning of the parameter.
For example:
qtag1, qtag2 — Specifies the encapsulation value used to identify the SAP on the port or sub-port. If this
parameter is not specificially defined, the default value is 0.
Values
The values depends on the encapsulation type configured for the interface. The following table
describes the allowed values for the port and encapsulation types.
Port Type Encap-Type
Ethernet Null
Ethernet Dot1q
Ethernet QinQ
SONET/SDH IPCP
SONET/SDH BCP-Null
TDM
SONET/SDH BCP-Dot1q
TDM
SONET/SDH Frame Relay
TDM
SONET/SDH ATM
ATM
Page 664
*A:ALA-12>config#
*A:ALA-12>config>port# multilink-bundle
The command syntax must be configured as follows:
bpgrp-id:
type:
bpgrp-num value range:
*A:ALA-12>config# port bpgrp-ima-1
*A:ALA-12>config>service>vpls$ sap bpgrp-ima-1
qtag1:
qtag2 :
Allowed Values
0
0 — 4094
qtag1: 0 — 4094
qtag2: 0 — 4094
-
0
0 — 4094
16 — 991
vpi (NNI) 0 — 4095
vpi (UNI) 0 — 255
vci 1, 2, 5 — 65535
port bundle-ppp-5/1.1
bpgrp-type-bpgrp-num
ima
1 — 2000
* | 0 — 4094
* | 0 — 4094
The SAP is identified by the port.
The SAP is identified by the 802.1Q tag on the port.
Note that a 0 qtag1 value also accepts untagged packets
on the dot1q port.
The SAP is identified by two 802.1Q tags on the port.
Note that a 0 qtag1 value also accepts untagged packets
on the Dot1q port.
The SAP is identified by the channel. No BCP is
deployed and all traffic is IP.
The SAP is identified with a single service on the
channel. Tags are assumed to be part of the customer
packet and not a service delimiter.
The SAP is identified by the 802.1Q tag on the channel.
The SAP is identified by the data link connection
identifier (DLCI).
The SAP is identified by port or by PVPC or PVCC
identifier (vpi, vpi/vci, or vpi range)
7750 SR OS Router Configuration Guide
Comments