Filter Management Tasks
Deleting a Filter Policy
Before you can delete a filter, you must remove the filter association from all the applied ingress
and egress SAPs and network interfaces by executing no filter command in all context where the
filter is used.
The following illustrates an example of removing a filter (filter ID 11) from an ingress ePipe SAP:
Example
After you have removed the filter from the SAPs network interfaces, you can delete the filter as
shown in the following example.
Example
Page 466
:
config>service# epipe 5
config>service>epipe# sap 1/1/2:3
config>service>epipe>sap# ingress
config>service>epipe>sap>ingress# no filter
:
config>filter# no ip-filter 11
7750 SR OS Router Configuration Guide