iBox/iBox Kit
Installation and Maintenance Guide
Configuring and Testing your iBox Kit Components
Configuration
If you are operating the iBox Kit through a LAN, the process for configuring and
Sequence –
testing the iBox Kit components is as follows:
LAN
connection
Note: The first time you configure the iBox in an iBox Kit, you will do it through
The procedures for configuring an iBox Kit with a LAN connection are as follows:
Configuration
Procedures –
•
Restoring your SGConfig Project on page 91
LAN
Configuring the Application Firmware on page 96
•
connection
•
Configuring Project Properties on page 98
•
Configuring iBox Device Properties - LAN on page 101
•
Configuring the iBox PPP Driver on page 103
•
Configuring iBox Communications Options - LAN on page 105
•
Downloading your iBox Configuration - LAN on page 108
•
Configuring the Ethernet Module on page 109
•
Configuring the DC Analog Module on page 123 (if equipped)
•
Configuring the AC Analog Module on page 130 (if equipped)
•
Testing the iBox Kit on page 131
90
Restore Config Pro
Project
Configure Project
Properties for LAN
Connection
Configure iBOX
Device Properties for
LAN Connection
Configure iBOX PPP
Driver
Configure iBOX
Communication
Options for LAN
Connection
the WESMAINT serial port. Once you have configured the iBox, you will be
able to download subsequent configurations over the LAN.
994-0047-5.10-4
GE Grid Solutions
, continued
Configure Application
Firmware
Download iBOX
configuration through
WESMAINT port
Configure Ethernet
Module
Configure AC or DC
Analog Input Module
(if equipped)
Test iBOX Kit
GE Information
Need help?
Do you have a question about the iBox and is the answer not in the manual?
Questions and answers