GE iBox Installation And Maintenance Manual page 64

iBox/iBox Kit
Installation and Maintenance Guide
Deleting Configuration Files
Erase a configuration file from the iBox's NVRAM before downloading a new code
Erasing a
file into FLASH memory, unless the code file is exactly the same as the one that was
Configuration
in use before the download.
There are two ways to erase a configuration file from the iBox memory:
Restoring the
Step
Default
1
Configuration
2
Erasing the
Step
Configuration
1
File
2
64
Reboot the iBox. While it is starting, press the
Result: The following message appears:
Are you sure you wish to generate a
default configuration [y\n]?
Type Y and press
ENTER
Result: The configuration restores to default.
With a terminal connected to the iBox 68K Monitor, type DHW (Display
HardWare) or SI (System Information) on older units.
Result: A listing of information, including the start address and size of
the NVRAM used for the configuration file, displays. The
NVRAM end address can be calculated by adding the NVRAM
size to the NVRAM start address.
Type F 00 <NVRAM Start Address> <NVRAM End Address> and press
.
ENTER
Result: The specified range of NVRAM fills with 0s, erasing any
configuration files.
994-0047-5.10-4
GE Grid Solutions
Action
key.
ESCAPE
Action
GE Information