GE iBox Installation And Maintenance Manual page 109

GE Grid Solutions
Configuring the Ethernet Module
Introduction The following procedure describes the configuration of the Digi One IAP Ethernet
Module.
Procedure: You need to set the Digi One Ethernet and PPP IP addresses. Refer to "IP
Configuring Addressing" on page 81 for an explanation. You also need to change the Digi One
the Digi One root password.
IAP
Step
1
GE Information
Connecting to the Digi One
Connect a PC to the Digi One IAP's RJ45 connector either directly, as
shown below:
PC running
a Web browser, IP address in
the same subnet as the
Ethernet Module
Crossover Ethernet
or through the network:
PC running
a Web browser, IP address in
the same subnet as the
Ethernet Module
LAN
Straight-through
Ethernet Cable
Installation and Maintenance Guide
Action
Digi One
IAP
Cable
Digi One
IAP
994-0047-5.10-4
iBox/iBox Kit
iBOX Kit
iBOX Kit
Continued on next page
109