iBox/iBox Kit
Installation and Maintenance Guide
Configuring and Testing your iBox Kit Components
Before you
To configure an iBox Kit with a serial connection, you will need:
Start
•
Factory configuration for your iBox. You can find this on the configuration CD
that shipped with your iBox Kit.
•
SGConfig installed on your PC.
•
Serial number of your iBox, from the iBox circuit board
To configure an iBox Kit with a LAN connection, you will need, in addition to the
above:
•
IP address/subnet mask of the LAN, iBox and Ethernet Module
•
Gateway address, if your iBox is connected to the LAN through a router.
•
Factory configuration for your Ethernet Module. You can find this on the
configuration CD.
Configuration
If you are operating the iBox Kit through a serial port, the process for configuring
Sequence –
and testing the iBox Kit components is as follows:
Serial
Connection
88
Restore Config Pro
Project
Configure Project
Properties for serial
connection
Configure iBOX
Device Properties for
serial connection
Configure iBOX
Communication
Options for serial
connection
994-0047-5.10-4
GE Grid Solutions
, continued
Configure Application
Firmware
Download iBOX
configuration through
WESMAINT port
Configure AC or DC
Analog Input Module
(if equipped)
Test iBOX Kit
Continued on Next Page
GE Information