GE iBox Installation And Maintenance Manual page 128

iBox/iBox Kit
Installation and Maintenance Guide
Configuring the DC Analog Module
Procedure:
Step
Configuring
12
the ADAM-
4017+
(continued)
13
14
15
16
17
18
Procedure: You may wish to modify the default point descriptions for the DC Analog Inputs to
Modifying the more meaningful descriptions for your system. Follow these steps to change the
Point point descriptors of the DC analog inputs.
Descriptors
Step
1
2
3
4
5
6
128
, continued
Click Update, then OK when you receive the message that the setup was
successful:
Remove power to the ADAM-4017+.
Change the ADAM-4017+ operating mode switch from Init back to
Normal.
Restore power to the ADAM-4017+.
In the ADAM-4000 Utility, click
Result: The device configuration is now consistent with the change or
changes you made.
Remove power to the ADAM-4017+.
Disconnect the ADAM-4017+ from the RS-485/RS-232 converter, and
reconnect it to the iBox.
Open the iBox Kit device in SGConfig, open the Applications List, and
click the System Point Database Applications tab.
Double-click the System Point Database icon.
Result: The System Point Database Properties window displays.
On the DCA/DTA List tab, select MODBUS DCA and click the
Descriptors button.
Result: The Point Descriptors window appears.
Click the Analog Inputs tab on the bottom of the window. Enter new
Point Descriptions as desired. Click OK.
On the DCA/DTA List tab, select Calculator DTA and click the
Descriptors button.
Result: The Point Descriptors window appears.
Click the Analog Inputs tab on the bottom of the window. Enter new
Point Descriptions as desired. Click OK twice.
Result: SGConfig updates the configuration tables.
994-0047-5.10-4
GE Grid Solutions
Action
.
Action
GE Information