Publickey Authentication Enabled Stelnet Server Configuration Example - HP 6600 Security Configuration Manual

2. Establish a connection to the Stelnet server:
The device supports a variety of Stelnet client software, such as PuTTY, and OpenSSH. The
following example takes PuTTY Version 0.58 on the Stelnet client.
To establish a connection to the Stelnet server:
a. Launch PuTTY.exe to enter the following interface.
b. In the Host Name (or IP address)field, enter the IP address of the Stelnet server.
Figure 108 Specifying the host name (or IP address)
c. Click Open to connect to the server.
If the connection is successfully established, the system asks you to enter the username and
password. After entering the username (client001) and password (aabbcc), you can enter the
command-line interface of the server.
Publickey authentication enabled Stelnet server configuration
example
Network requirements
As shown in
The router acts as the Stelnet server, adopting publickey authentication and the RSA public key algorithm.
Figure 109, you can log in to the router through the Stelnet client (SSH2) that runs on the host.
331