HP 6600 Security Configuration Manual page 177

Configuring the portal server
This example assumes that the portal server runs on IMC PLAT 5.1 SP1 (E0202P05) and IMC UAM 5.1
(E0301).
1. Configure the portal server:
a. Log in to IMC and select the Service tab.
b. Select User Access Manager > Portal Service > Server from the navigation tree to enter the
portal server configuration page, as shown in
Configure the portal server parameters as needed.
c.
This example uses the default settings.
d. Click OK.
Figure 64 Portal server configuration
2. Configure the IP address group:
a. Select User Access Manager > Portal Service > IP Group from the navigation tree to enter the
portal IP address group configuration page.
b. Click Add to enter the page shown in
c. Enter the IP group name.
d. Enter the start IP address and end IP address of the IP group.
Make sure that the host IP address is in the IP group.
e. Select a service group.
By default, the group Ungrouped is used.
f. Select the IP group type Normal.
g. Click OK.
Figure 64.
Figure 65.
163