Configuration Example For Qinq Termination Supporting Pppoe Server; Configuration Example For Qinq Termination Supporting Dhcp Relay - HP A6600 Configuration Manual

Configuration example for QinQ termination supporting PPPoE
server
Network requirements
As shown in
11, VLAN 12, and VLAN 13, respectively. QinQ is enabled on Switch B. Host A, Host B, and Host C
need to dial up to the Internet.
Figure 64 Network diagram for configuring QinQ termination to support PPPoE Server
Configuration procedure
For more information about VLAN and QinQ termination configuration, see
termination configuration
configure related PPPoE settings on GigabitEthernet 4/1/1.10 on the router. For how to configure PPPoE
settings, see Layer 2—WAN Configuration Guide.
Configuration example for QinQ termination supporting DHCP
relay
Network requirements
As shown in
• Provider A and Provider B are edge devices on the service provider network.
• DHCP client A and DHCP client B are devices on the customer networks.
• Provider A is the DHCP relay agent and Provider B is the DHCP server.
• Provider A and Provider B communicate with each other through Layer 3 interfaces.
Figure 64, Host A, Host B, and Host C are connected to Switch A and they belong to VLAN
example." Because the router is the PPPoE server in the network, you must
Figure 65:
174
"Ambiguous QinQ