HP 6600 Security Configuration Manual page 207

Quiet-interval(min)
Username format
Data flow unit
Packet unit
# Display the configuration of the ISP domain sun.
[Router] display domain sun
Domain : sun
State : Active
Access-limit : 30
Accounting method : Required
Default authentication scheme
Default authorization scheme
Default accounting scheme
Domain User Template:
Idle-cut : Disabled
Session-time : exclude-idle-time
Self-service : Disabled
Authorization attributes:
# Display the port security configuration.
<Router> display port-security interface gigabitethernet 3/0/1
[Router] display port-security interface gigabitethernet 3/0/1
Equipment port-security is enabled
Intrusion trap is enabled
AutoLearn aging time is 30 minutes
Disableport Timeout: 30s
OUI value:
Index is 1, OUI value is 123401
Index is 2, OUI value is 123402
Index is 3, OUI value is 123403
Index is 4, OUI value is 123404
Index is 5, OUI value is 123405
GigabitEthernet3/0/1 is link-up
Port mode is userLoginWithOUI
NeedToKnow mode is disabled
Intrusion Protection mode is NoAction
Max MAC address number is not configured
Stored MAC address number is 0
Authorization is permitted
Security MAC address learning mode is sticky
Security MAC address aging type is absolute
After an 802.1X user gets online, you can see that the number of secure MAC addresses stored is 1.
# Display 802.1X information.
[Router] display dot1x interface GigabitEthernet 3/0/1
Equipment 802.1X protocol is enabled
CHAP authentication is enabled
Proxy trap checker is disabled
: radius:radsun
: radius:radsun
: radius:radsun
193
: 5
: without-domain
: Byte
: one