HP 6600 Security Configuration Manual page 69

Figure 10 Network diagram
Configuring the RADIUS server
This section assumes that the RADIUS server runs on IMC PLAT 5.1 SP1 (E0202P05) and IMC UAM 5.1
(E0301).
1. Add the router to the IMC Platform as an access device:
a. Log in to IMC, click the Service tab, and select User Access Manager > Access Device
Management > Access Device from the navigation tree.
b. Click Add to configure an access device as follows:
Set the shared key for secure authentication and accounting communication to expert.
Set the ports for authentication to 1812, respectively.
Select the service type Device Management Service.
Select the access device type HP(General).
Select the access device from the device list or manually add the access device (with the IP
address 10.1.1.2).
c. Click OK.
The IP address of the access device specified here must be the same as the source IP address of the
RADIUS packets sent from the device, which is chosen in the following order:
IP address specified with the nas-ip command on the device.
IP address specified with the radius nas-ip command on the device.
IP address of the outbound interface (the default).
55