HP 6600 Security Configuration Manual page 78

Figure 17 List of the usernames for privilege level switching
3. Verify the configuration.
After the configuration is complete, the user can Telnet to the router and use username test@bbb
and password aabbcc to enter the user interface of the router, and access all level 0 commands.
<Router> telnet 192.168.1.70
Trying 192.168.1.70 ...
Press CTRL+K to abort
Connected to 192.168.1.70 ...
******************************************************************************
* Copyright (c) 2013 Hewlett-Packard Development Company, L.P.
* Without the owner's prior written consent,
* no decompiling or reverse-engineering shall be allowed.
******************************************************************************
Login authentication
Username:test@bbb
Password:
<Router> ?
User view commands:
cluster Run cluster command
display Display current system information
ping Ping function
quit Exit from current command view
ssh2 Establish a secure shell client connection
super Set the current user priority level
telnet Establish one TELNET connection
tracert Trace route function
When switching to user privilege level 3, the Telnet user only needs to enter password pass3 as
prompted.
<Router> super 3
Password:
User privilege level is 3, and only those commands can be used
whose level is equal or less than this.
Privilege note: 0-VISIT, 1-MONITOR, 2-SYSTEM, 3-MANAGE
If the RADIUS authentication is not available, the Telnet user needs to enter password 654321 as
prompted for local authentication.
<Router> super 3
64
*
*
*