Configuring Port Security Features; Configuring Ntk; Configuring Intrusion Protection - HP 6600 Security Configuration Manual

Configuring port security features

Configuring NTK

The NTK feature checks destination MAC addresses in outbound frames to make sure frames are
forwarded only to authenticated devices. Any unicast frame with an unknown destination MAC address
is discarded. Not all port security modes support triggering the NTK feature. For more information,
see Table 8.
The NTK feature supports the following modes:
ntkonly—Forwards only unicast frames with authenticated destination MAC addresses.
•
ntk-withbroadcasts—Forwards only broadcast frames and unicast frames with authenticated
•
destination MAC addresses.
ntk-withmulticasts—Forwards only broadcast frames, multicast frames, and unicast frames with
•
authenticated destination MAC addresses.
To configure the NTK feature:
Step
1. Enter system view.
2. Enter interface view.
3. Configure the NTK feature.

Configuring intrusion protection

Intrusion protection enables a device to take one of the following actions in response to illegal frames:
blockmac—Adds the source MAC addresses of illegal frames to the blocked MAC addresses list
•
and discards the frames. All subsequent frames sourced from a blocked MAC address will be
dropped. A blocked MAC address is restored to normal state after being blocked for 3 minutes. The
interval is fixed and cannot be changed.
disableport—Disables the port until you bring it up manually.
•
• disableport-temporarily—Disables the port for a specific period of time. The period can be
configured with the port-security timer disableport command.
On a port
macAddressElseUserLoginSecureExt mode, intrusion protection is triggered only after both MAC
authentication and 802.1X authentication fail for the same frame.
To configure the intrusion protection feature:
Step
1. Enter system view.
2. Enter interface view.
Command
system-view
interface interface-type
interface-number
port-security ntk-mode
{ ntk-withbroadcasts |
ntk-withmulticasts | ntkonly }
operating in either
Command
system-view
interface interface-type
interface-number
the macAddressElseUserLoginSecure
184
Remarks
N/A
N/A
By default, NTK is disabled on a
port and all frames are allowed to
be sent.
mode
Remarks
N/A
N/A
or the